NordicTrack 24928.0, User Manual

25

11. Enable or disable a passcode.

The console features a child-safety passcode, 

designed to prevent unauthorized users from using 

the incline trainer.

Touch the Passcode button. To enable a pass-

code, touch the Enable checkbox. Then, enter a 

4-digit passcode of your choice. Touch Save to use 

this passcode. Touch Cancel to return to the equip-

ment settings mode and not use a passcode. To 

disable the passcode, touch the Disable checkbox.

   Note: If a passcode is enabled, the console will 

regularly ask for you to enter the passcode. The 

console will remain locked until the correct pass-

code is entered.

 IMPORTANT: If you forget your 

passcode, enter the following master passcode 

to unlock the console: 1985.

12. Set a safety screen timeout.

   The console features an automatic screen reset; if 

no buttons are touched or pressed and the walking 

belt does not move for a set amount of time, the 

console will automatically reset.

   To set the amount of time the console will wait 

before it automatically resets, touch the Safety 

Screen Timeout button to view a list of times. Then, 

select the amount of time desired. Touch the back 

button on the screen.

13. Exit the equipment settings mode.

To exit the equipment settings mode, touch the 

back button on the screen.

HOW TO USE THE SOUND SYSTEM

To play music or audio books through the console 

sound system while you exercise, plug a 3.5 mm male 

to 3.5 mm male audio cable (not included) into the jack 

on the console and into a jack on your MP3 player, 

CD player, or other personal audio player; 

make sure 

that the audio cable is fully plugged in. Note: To 

purchase an audio cable, see your local electronics 

store.

Next, press the play button on 

your personal audio player. Adjust 

the volume level using the volume 

increase and decrease buttons on 

the console or the volume control 

on your personal audio player. 

If you are using a personal CD player and the CD 

skips, set the CD player on the floor or another flat 

surface instead of on the console.

HOW TO USE THE INTERNET BROWSER

Note: To use the browser, you must have access to a 

wireless network including an 802.11b/g/n router with 

SSID broadcast enabled (hidden networks are not 

supported).

To open the browser, touch the globe button near the 

lower left corner of the screen. Then, select a website.

To navigate the Internet browser, touch the Back, 

Refresh, and Forward buttons on the screen. To exit 

the Internet browser, touch the Return button on the 

screen.

To use the keyboard, see HOW TO USE THE TOUCH 

SCREEN on page 16.

To enter a different web address in the URL bar, first, 

slide your finger down the screen to view the URL bar, 

if necessary. Then, touch the URL bar, use the key-

board to enter the address, and touch the Go button.

Note: While you are using the browser, the speed, 

incline, fan, and volume buttons will still function, but 

the workout buttons will not function.

Note: If you have questions after following these 

instructions, go to support.iFit.com for assistance.

ETS199913 (24928)