17
14
15
14. Untie and discard the wire tie attached to the
Wire Harness (60).
While a second person holds the Console (33)
near the Upright (5), connect the wires on the
Console to the Wire Harness (60) and to the
Pulse Wires (105).
Insert the excess wire into the Upright (5).
Tip: Avoid pinching the wires.
Finger tighten
two M4 x 19mm Screws (80) through the Upright
(5) into the upper end of the Console (33).
Make
sure to start the Screws into the indicated
upper holes in the Console.
Do not tighten the M4 x 19mm Screws (80)
yet. You will tighten the Screws at the end of
step 16.
33
105
5
60
25
80
5
15. Orient the Rear Upright Cover (25) as shown.
Attach the Rear Upright Cover (25) to the Upright
(5) with four M4 x 19mm Screws (80).
Tip: It
may be necessary to bend the upper end
of the Rear Upright Cover gently into place
around the Upright.
Avoid pinching
the wires
80
Upper
Holes
Summary of Contents for 29826.3
Page 5: ...5...
