NordicTrack 30710.0, User Manual

16

5. Measure your heart rate if desired.

If there are

sheets of clear

plastic on the

metal contacts

on the handgrip

pulse sensor,

remove the plas-

tic. In addition,

make sure that

your hands are

clean. To measure

your heart rate, hold the handgrip pulse sensor

with your palms resting against the metal contacts.

Avoid moving your hands or gripping the con-

tacts tightly.

When your pulse is detected, a heart-shaped sym-

bol will flash in the display each time your heart

beats and then your heart rate will be shown. For

the most accurate heart rate reading, hold the con-

tacts for at least 15 seconds. 

If your heart rate is not shown, make sure that your

hands are positioned as described. Be careful not

to move your hands excessively or to squeeze the

metal contacts tightly. For optimal performance,

clean the metal contacts using a soft cloth; never

use alcohol, abrasives, or chemicals to clean

the contacts.

6. Turn on the fan if desired.

To turn on the fan at high speed, press the Fan

button. To turn on the fan at low speed, press the

Fan button a second time. To select the auto

mode, press the Fan button a third time; while the

auto mode is selected, the speed of the fan will

automatically increase or decrease as you

increase or decrease your pedaling speed. 

Pivot the thumb

tab on the right

side of the fan to

adjust the fan

angle.

To turn off the fan, press the Fan button again.

Note: If the pedals do not move for about thirty

seconds, the fan will automatically turn off to con-

serve the batteries.

7. When you are finished exercising, the console

will turn off automatically.

If the pedals do not move for several seconds, a

series of tones will sound and the console will

pause.

If the pedals do not move for about five minutes,

the console will turn off and the displays will be

reset.

Contacts

Thumb

Tab