12
4
8
12
13
12. While a second person holds the Console (8)
near the Upright (4), plug the Upper Wire (116)
and the Pulse Wire (117) into the matching
receptacles on the back of the Console.
The connectors on the Upper Wire (116) and
the Pulse Wire (117) should slide easily into
the receptacles and snap into place.
If a con-
nector does not slide easily into a receptacle,
turn the connector and try again.
If you do not
connect the connectors properly, the console
may become damaged.
Tip: Avoid pinching the wires.
Attach the
Console (8) to the Upright (4) with four M4 x
16mm Screws (97).
Avoid pinching
the wires
116
97
117
33
11
PTFE
Grease
48
14
15.
Make sure that all parts are properly tightened before you use the elliptical.
Note: Extra parts may be
included. Place a mat beneath the elliptical to protect the floor.
14. Plug the Power Adapter (114) into the receptacle
on the frame of the elliptical.
Note: To plug the Power Adapter (114) into an
outlet, see HOW TO PLUG IN THE POWER
ADAPTER on page 13.
114
13. Apply a small amount of the included PTFE
grease to a paper towel. Spread a thin layer of
the PTFE grease evenly along the Right and Left
Tracks (11, 33) where the Rollers (48) move.
Then, wipe off any excess grease.
