7
Assembly requires two persons.
Set the INCLINE TRAINER in a cleared area and remove all packing materials.
Do not dispose of the packing materials until assembly is completed.
Assembly can be completed using the
included allen wrenches.
3. Connect the Right Upright Wire Harness (105), the TV
Cable (33), and the Left Upright Wire Harness (131) in
the indicated locations.
The connectors should slide
together easily and snap into place.
If they do not, turn
the connector and try again.
IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS TURNED
ON.
Push all of the excess wire up into the Uprights (96,
107).
Make sure that all wires are fully connected.
Note: Regardless of which console your INCLINE
TRAINER has, connect all wires so that the console
can later be upgraded if desired.
Refer to step 1. While a second person holds the
Uprights (96, 107), remove the Upright Bolts (106). Slide
the Uprights fully onto the Base Frame (52).
Be careful
to avoid pinching your hands or the wires.
2. While a second person holds the Handrail (94) near the
Uprights (96, 107), feed the wires in both sides of the
Handrail down into the Uprights. Pull the ends of the
wires out of the lower ends of the Uprights and remove
the wire ties from the ends of the wires.
Finger tighten four Handrail Bolts (93) into the Handrail
(94) and the Uprights (96, 107) as shown.
Be careful to
avoid pinching the wires in the Handrail.
Note: The Accessory Holder (142) and the Cup Holder
(10) are replaceable. If these parts become dislodged
from the Console (89), press them back into place.
94
107
96
93
142
89
10
93
Wires
2
H
OW TO
S
ET
U
P THE
I
NCLINE
T
RAINER
107
96
105
33 131
3
1. Slide the Right and Left Uprights (96, 107) onto the
brackets near the front of the Base Frame (52).
Make
sure that the Uprights are on the correct sides; the
indicated holes must be facing the INCLINE
TRAINER.
Raise the Left Upright (107) until the lower hole in the
front of the Upright is aligned with the upper hole in the
bracket as shown. Thread an Upright Bolt (106) into the
Upright and the bracket.
Do not fully tighten the
Upright Bolt yet.
Repeat this step with the Right Upright (96).
107
52
52
Holes
106
106
96
1
