7
3. Identify the Right Upright (78) and the Right
Upright Spacer (79), which are marked with
stickers. Insert the Upright Wire (38) through the
Right Upright Spacer as shown. Set the Spacer
on the Base (83).
See the inset drawing.
Tie the wire tie in the
Right Upright (78) securely around the end of
the Upright Wire (38). Be sure that the wire tie
goes through the indicated hole in the Right
Upright.
With the help of a second person, hold the Right
Upright (78) near the Base (83). Then, pull the
other end of the wire tie until the Upright Wire
(38) is routed completely through the Right
Upright.
83
38
78
79
Wire Tie
38
3
2. Remove the 3/8" Nut (8) and 3/8" x 2" Bolt (4)
from the Base (83). Attach a Wheel (84) with the
Bolt and the Nut that you just removed.
Do not
overtighten the Nut; the Wheel must turn
freely.
83
4
8
2
84
Wire
Tie
78
Hole
38
1.
Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (56) so that the treadmill is more stable;
do not fully fold the Frame yet.
Cut the tie securing the Upright Wire (38) to the
Base (83). Locate the tie in the indicated hole in
the Base, and use the tie to pull the Upright Wire
out of the hole.
Attach a Base Pad (81) to the Base (83) in the
location shown with a Base Pad Spacer (13) and
a #8 x 1" Tek Screw (2). Then, attach another
Base Pad (81) with only a #8 x 1" Tek Screw (2).
83
2
56
81
1
81
2
38
Hole
13
