23
When you select an iFit Live workout, the display
will show the duration of the workout, the distance
you will walk or run, and the approximate number
of calories you will burn. The display may also
show the name of the workout. If you select a com-
petition workout, the display will count down to the
beginning of the race.
Note: Each iFit Live button can also run two demo
workouts. To use the demo workouts, remove the
iFit Live module from the console and press one of
the iFit Live buttons.
5. Start the workout.
See step 3 on page 21.
During some workouts, the voice of a personal
trainer will guide you through your workout. You
can select an audio setting for your personal trainer
(see THE INFORMATION MODE on page 24).
To stop the workout at any time, press the Stop
button. The time will begin to flash in the display.
To resume the workout, press the Start button or
the Speed increase button. The walking belt will
begin to move at the speed setting for the first
segment of the workout. When the next segment of
the workout begins, the treadmill will automatically
adjust to the speed and incline settings for the next
segment.
6. Follow your progress with the displays.
See step 5 on page 20.
The My Trail tab will show a map of the trail you are
walking or running or it will show a track and the
number of laps you complete.
During a competition workout, the Competition tab
will show your progress in the race. As you race,
the top line in the matrix will show how much of the
race you have completed. The other lines will show
your top four competitors. The end of the matrix
represents the end of the race.
7. Measure your heart rate if desired.
See step 6 on page 20.
8. Turn on the fan if desired.
See step 7 on page 21.
9. When you are finished exercising, remove the
key from the console.
See step 8 on page 21.
For more information about the iFit Live mode, go
to www.iFit.com.
HOW TO USE THE STEREO SOUND SYSTEM
To play music or audio books through the console’s
stereo speakers, you must connect your MP3 player,
CD player, or other personal audio player to the con-
sole through the audio jack below the speakers.
To use the audio jack, locate the included audio wire
and plug it into the audio jack. Then, plug the audio
wire into a jack on your MP3 player, CD player, or
other personal audio player. Make sure that the audio
wire is fully inserted.
Next, press the play button
on your MP3 player, CD
player, or other personal
audio player. Adjust the vol-
ume on your personal audio
player or press the volume
increase and decrease but-
tons on the console.
If you are using a personal CD player and the CD
skips, set the CD player on the floor or another flat
surface instead of on the console.
Decrease
Increase
