8
6. Set the Left Upright Spacer (76) on the Base
(83). Insert two 3/8" x 5" Bolts (6) with two 3/8"
Star Washers (9) into the Left Upright (74), and
set the Left Upright in the Left Upright Spacer. If
necessary, use a rubber mallet to make sure
that the Left Upright is fully seated in the Left
Upright Spacer.
Partially tighten the 3/8" x 5" Bolts (6);
do not
fully tighten the Bolts yet.
Press a Base Endcap (80) into the Base (83).
With the help of a second person, tip the tread-
mill so that the Base (83) is flat on the floor.
76
74
6
83
80
6
5. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (56) so the treadmill is more stable;
do
not fully fold the Frame yet.
Attach a Base Pad (81) to the Base (83) in the
location shown with a #8 x 1" Tek Screw (2) and
a Base Pad Spacer (13). Then, attach another
Base Pad (81) with only a #8 x 1" Tek Screw (2).
Remove the 3/8" Nut (8) and the 3/8" x 2"
Shoulder Bolt (112) from the Base (83). Attach a
Wheel (84) with the Bolt and the Nut that you
just removed.
Do not overtighten the Nut; the
Wheel must turn freely.
5
83
84
56
112
8
81
2
81
13
4. Insert two 3/8" x 5" Bolts (6) with two 3/8" Star
Washers (9) into the Right Upright (78), and set
the Right Upright in the Right Upright Spacer
(79). If necessary, use a rubber mallet to make
sure that the Right Upright is fully seated in the
Right Upright Spacer.
Be careful not to pinch
the Upright Wire (38).
Partially tighten the 3/8" x 5" Bolts (6);
do not
fully tighten the Bolts yet.
Press a Base Endcap (80) into the Base (83).
79
78
80
6
4
83
38
9
9
2
