8
5. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin.
Press the Latch Insert (77) into the right side of the left
Upright (85), and press the Knob Insert (92) into the left
side of the left Upright. Use a rubber mallet, if necessary.
Next, insert the pin into the Latch Insert, and tighten the
knob back onto the pin.
77
92
5
Knob
85
Pin
Collar
Spring
6.
Make sure that all parts are properly tightened before you use the treadmill.
Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 26).
To protect the
floor or carpet from damage, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1.
Make sure that the power cord is unplugged.
Remove
the indicated Screw (7) and the Access Door (95) from
the left side of the Console Back (98).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (98).
Hold the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back.
Attach the receiver to the
plastic posts on the Access Door (95) with the two in-
cluded small screws.
3.
Make sure that no wires are pinched.
Reattach the
Access Door (95) with the Screw (7). Discard the other
wires included with the receiver.
A
98
Small
Cylinder
7
95
Wire
Small
Screws
