7
2. With the help of a second person, carefully tip the Frame
(55) and the Uprights (85) down to the position shown.
Make sure that the Base Extension (90) remains in the
Uprights.
Carefully slide the Base Cover (92) onto the bottom of the
Uprights (85). Attach the Base Cover with four 3/4” Tek
Screws (44);
start all four Tek Screws before tighten-
ing them. Be careful not to overtighten the Tek
Screws.
92
90
44
55
85
2
3. Attach the Base Extension (90) with four Extension
Screws (87);
start all four Extension Screws before
tightening them.
Attach the two Thin Base Pads (83) to the base of the
Uprights (85) in the locations shown with two 1” Tek
Screws (82).
Note: Replacement Base Pads may be included. Use the
Base Pads to replace any that becomes worn.
With the help of a second person, carefully tip the
Uprights (85) back to the vertical position.
87
85
83
82
87
90
83
82
3
4. While the other person holds the Frame (55), press the
smaller end of the Shock (86) onto the bracket in the cen-
ter of the Uprights (85).
Make sure to orient the Shock
as shown.
Press the other end of the Shock onto the
bracket in the center of the Frame. Note: It may be neces-
sary to tip the Frame forward or back to attach the Shock.
Do not tip the Frame forward past the vertical posi-
tion.
85
4
86
55
