12
13.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used
to adjust the walking belt (see pages 32 and 33).
12. Note the location of the 75 ohm terminal and the
audio/video input jack on the treadmill. For the
television to operate, the 96" AV Cable (130)
must be connected to the audio/video input jack
on the treadmill or a CATV cable must be con-
nected to the 75 ohm terminal (see page 13).
12
130
75 Ohm
Terminal
Audio/Video
Input
10. Tighten two #8 x 1/2" Machine Screws (4) into
the bottom of the handrail assembly.
Be careful
not to overtighten the Machine Screws.
See step 9.
Tighten the six #8 x 2 1/4" Machine
Screws (3).
Be careful not to overtighten the
Machine Screws.
11. If necessary, move the treadmill to the desired
location (see HOW TO MOVE THE TREADMILL
on page 31).
After the treadmill is placed in the location where
it will be used, make sure that the Leveling Feet
(64) rest firmly on the floor. If the treadmill rocks
even slightly, loosen one of the 1/2" Nuts (36),
turn the Leveling Foot clockwise or counter-
clockwise until the rocking motion is eliminated,
and retighten the Nut.
64
11
36
10
Handrail
Assembly
4
4
