10
7. Have a second person hold the console assem-
bly near the handrail assembly. Connect the 25"
A/V Wire (107) and the 25" TV Cable (108) to
the cables extending from the console assembly.
Connect the 25" Wire Harness (103) to the wire
extending from the console assembly.
See the
inset drawing. The connectors should slide
together easily and snap into place.
If they do
not, turn one connector and try again.
IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Connect the Console Ground Wires (96) to the
two ground wires extending from the console
assembly.
Set the console assembly on the handrail as-
sembly. If necessary, move the wires so that the
console assembly sits flat on the handrail as-
sembly.
Be careful not to pinch any wires.
Note: If the console assembly does not sit flat
on the handrail assembly, you will not be able to
complete step 8.
107
103
7
Console
Assembly
Cables
Wire
6. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Slide the three tabs on the Console Accent
(102) into the console assembly.
Press on the ends of the Console Accent (102)
until they snap into the slots in the console as-
sembly.
Console
Assembly
Slot
Slot
102
6
108
Wire
103
Tab
Tab
Handrail
Assembly
Ground
Wires
Hole
96
