21
Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap.
IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in. If the console does not
display your heart rate when you hold the handgrip
pulse sensor, or if the displayed heart rate appears to
be too high or too low, see step 5 on page 15.
HOW TO CALIBRATE THE RAMP
If the ramp is not functioning properly, the ramp may
need to be calibrated. To calibrate the ramp, hold
down the Start button and the Resistance increase
button for about 5 seconds until the display on the
console changes. Next, press the Start button once,
and then press the Ramp increase button. The ramp
will move upward and downward as it calibrates.
When the ramp stops moving, the ramp is calibrated.
Then, press the Start button repeatedly to return to the
manual mode.
HOW TO ADJUST THE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest setting, the
belt may need to be adjusted.
To adjust the belt,
first carefully pry
off the right Disc
Cover (41) using
a flat screwdriver.
Next, remove the
four screws (not
shown) from the
center of the right
Pedal Disc (40).
Gently rotate the
Disc away from
the elliptical exerciser.
Loosen, but do
not remove, the
three indicated
screws (A). Insert
the shaft of a
screwdriver
downward
between the
Idler (B) and the
Idler Pulley (C).
Pull the top of the
screwdriver
toward the front
of the elliptical exerciser until the Belt (57) is tight.
Then, tighten the three screws.
Reattach the right disc with the four screws and then
reattach the right disc cover.
MAINTENANCE AND TROUBLESHOOTING
41
40
B
C
A
57
