4
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrenches and your own phillips screwdriver and
rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly.
The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 21.
The second number is the quantity used in assembly. Note: Some small parts may have been pre-assem-
bled. If a part is not in the parts bag, check to see if it is pre-assembled.
M8 x 56mm Button Screw (83)–4
M8 x 44mm Button Screw (84)–8
M10 Split
Washer (73)–2
7.6mm Spacer
(47)–2
M4 x 16mm
Round Head
Screw (69)–4
M8 x 79mm Bolt Set (65)–2
M10 x 108mm Button Screw (70)–2
M8 Split
Washer (85)–4
1. Identify the Front Stabilizer (8). While another person
lifts the front of the Frame (1) and holds the Pedal
Legs (4, 5) in the position shown, attach the Front
Stabilizer to the Frame with four M8 x 44mm Button
Screws (84) and a Support Plate (64).
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (not shown) to the Frame
in the same way.
1
8
4, 5
1
64
84
84
