12
13
14
13. Untie and discard the wire tie on the Wire
Harness (60).
While a second person holds the Console (33)
near the Upright (5), connect the wires on the
Console to the Wire Harness (60) and to the
Pulse Wires (105).
Insert the excess wire into the Upright (5).
Tip: Avoid pinching the wires.
Finger tighten
two M4 x 19mm Screws (156) through the
Upright (5) into the upper end of the Console
(33).
Make sure to start the Screws into the
indicated upper holes in the Console.
Do not tighten the M4 x 19mm Screws (156)
yet.
33
5
60
25
156
5
14. Orient the Rear Upright Cover (25) as shown.
Attach the Rear Upright Cover (25) to the Upright
(5) with four M4 x 19mm Screws (156).
Tip: It
may be necessary to bend the upper end
of the Rear Upright Cover gently into place
around the Upright.
105
Avoid pinching
the wires
Upper
Holes
156
