7
ASSEMBLY
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials.
Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex key and your own Phillips screwdriver .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly.
Note: If a part is not in the parts bag, check to see if it is preattached to
one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.
Extra hardware may be included.
crew (123)–2
1/2” Silver Screw
(48)–1
3/4” Tek Screw (58)–4
3
Spacer Screw (60)–2
1
4 1/2” Bolt (78)–4
1
Washer (96)–8
xtension Leg
Nut (106)–4
2
Star Washer
(90)–10
Nut (38)–2
3/8
5/16
Upright Bolt (72)–4
3/4" Screw (4)–4
Console Bolt (72)–4
Upper Latch Bolt (XX)–1
Lower Latch Bolt (XX)–1
Handrail Bolt (64)–6
1.
Make sure that the power cord is unplugged.
With the help of a second person, raise the front
of the treadmill and insert the crossbar on the
Base (83) into the cutout in the cardboard stand
as shown.
Have the second person hold the
treadmill to prevent it from moving forward
or backward until assembly step 2 is com-
pleted.
83
Cardboard
Stand
1
