23
HOW TO CHANGE CONSOLE SETTINGS
1. Select the settings mode.
To select the settings mode, press and hold down
the Display button for a few seconds until the set-
tings mode appears in the display.
The display will show the total number of hours
that the exercise bike has been used and the total
distance (in miles or kilometers) that has been
pedaled on the exercise bike.
If an iFit module is connected to the console, the
display will show the words WIFI MODULE or USB
MODULE.
If no module is connected, the display will show
the words NO IFIT MODULE. If no module is con-
nected, some of the settings options will not be
available.
2. Navigate the settings mode.
While the settings mode is selected, the matrix of
the display will display several optional screens.
Press the decrease button next to the Enter button
repeatedly to select the desired optional screen.
The lower section of the display will show instruc-
tions for the selected screen.
Make sure to follow
the instructions shown in the lower part of the
display.
3. Change settings as desired.
Demo
—The console features a display demo
mode, designed to be used if the exercise bike is
displayed in a store. Press the Enter button repeat-
edly to turn the demo mode ON or OFF.
Units
—The currently selected unit of measurement
will appear in the display. To change the unit of
measurement, press the Enter button repeatedly.
To view distance in miles, select ENGLISH. To view
distance in kilometers, select METRIC.
Contrast Level
—The currently selected contrast
level will appear in the display. Press the Incline
increase and decrease buttons to adjust the con-
trast level.
Trainer Voice
—The currently selected setting for
the audio coach will appear in the display. Press
the Enter button repeatedly to turn the audio coach
ON or OFF.
Default Menu
—The default menu will appear when
you press the Home button. Press the Enter button
repeatedly to select the manual mode or the iFit
menu as the default menu.
Check Status
—The words CHECK WIFI STATUS
or CHECK USB STATUS will appear in the display.
Press the Enter button. After a few seconds, the
status of the iFit module will appear in the display.
To exit this display, press the Settings button.
Send/Receive
—The words SEND/RECEIVE DATA
will appear in the display. Press the Enter button.
The console will then check for iFit workouts and
firmware downloads.
4. Exit the settings mode.
Press the Display button to exit the settings mode.
