15
19. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra parts may be included. Keep the included hex keys in a secure place; one of the hex keys is used
to adjust the walking belt (see pages 27 and 28).
18. Raise the Frame (56) to the position shown.
Orient the Storage Latch (53) so that the large
barrel and the latch knob are oriented as shown.
Attach the lower end of the Storage Latch (53) to
the Base (94) with a 3/8" x 2" Bolt (3) and a 3/8"
Nut (12).
Attach the upper end of the Storage Latch (53)
to the Frame (56) with a 3/8" x 2" Bolt (3) and a
3/8" Nut (12).
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 25).
18
53
56
3
Large
Barrel
Latch
Knob
12
3
94
12
17. Slide the Handrail Covers (79, 80) forward until
they match up with the Console Base (64).
Attach the Handrail Covers with the four #8 x
1 1/4" Screws (107) that you removed in steps
10 and 11. Do not overtighten the Screws.
Tighten four #8 x 3/4" Screws (2) into the con-
sole assembly in the locations shown.
Note: Some of the #8 x 3/4" Screws (2) are
designed to go in at different angles.
Raise the Base Covers (82, 83) and firmly
tighten the four 3/8" x 2 3/4" Screws (7) first and
then the 3/8" x 1 1/4" Screws (8) (only one side
is shown). Then, press the Base Covers into
place.
17
Console
Assembly
107
107
82
83
8
2
2
80
79
64
7
