22
Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If lines appear in the console display, see step 4 on
page 20 and adjust the contrast level of the display.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 16.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first unplug the power
adapter. Then, remove the left pedal and the left pedal
disc (see the instructions below).
Using an adjustable wrench, turn the left pedal clock-
wise and remove it.
Rotate the left
Pedal Disc (17)
clockwise to
release it from the
Left Shield (11).
Then, carefully
work the left Pedal
Disc off the Left
Crank Arm (20).
Locate the Reed Switch (57). Loosen, but do not
remove, the two M4 x 13mm Flange Screws (63).
Next, rotate the Left Crank Arm (20) until a Magnet (55)
is aligned with the Reed Switch (57). Slide the Reed
Switch slightly toward or away from the Magnet. Then,
retighten the M4 x 13mm Flange Screws (63).
Plug in the power adapter and rotate the Left Crank
Arm (20) for a moment. Repeat these actions until the
console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the left pedal disc and the left pedal.
MAINTENANCE AND TROUBLESHOOTING
20
17
11
57
63
55
20
