5
ASSEMBLY
Assembly requires two persons.
Place all parts of the elliptical strider in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
.
As you assemble the elliptical strider, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly.
Note: If a part is not in the hardware kit,
check to see if it has been preassembled.
3/8" x 1" Patch
Screw (122)–4
3/8" x 3/4" Patch
Screw (123)–2
3/8" x 3" Screw
(124)–2
M10 Split
Washer (128)–2
#8 x 3/4"
Screw (86)–16
#8 x 1" Tek
Screw (126)–8
#8 x 35mm
Screw (125)–1
