6
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. However, it is important to
realize that the versatile weight bench has many
parts and that the assembly process will take
time. Most people find that by setting aside plen-
ty of time, assembly will go smoothly.
23
2
Numbers
on this
side
Numbers
on this
side
Holes
on this
side
1
77
22
50
74
77
ASSEMBLY
1.
Press a 2” x 3” Square Inner Cap (50) into the
end of the Right Base (22).
Identify the Right Upright (2) by the positions of
the numbers and the holes. Attach the Right
Upright to the Right Base (22) with two M10 x
62mm Carriage Bolts (74) and two M10 Nylon
Locknuts (77). Note: Be sure that the numbers
on the Right Upright are on the side shown.
Do not tighten the Nylon Locknuts yet.
Repeat this step with the Left Base (23) and the
Left Upright (1). Note: Be sure the numbers on
the Left Upright are on the side shown in the
inset drawing.
1
Before beginning assembly, make sure you
understand the information in the box
above. Important: Some of the parts
described in the assembly steps may be
pre-assembled.
