7
3. Orient the Upright (4) and the Shield Cover (7)
as shown. Slide the Shield Cover upward onto
the Upright.
Have a second person hold the Upright (4)
and the Shield Cover (7) near the front of the
Frame (1).
Locate the wire tie inside the Upright (4). Tie
the lower end of the wire tie to the Main Wire
Harness (58).
Pull the other end of the wire tie upward until the
Main Wire Harness (58) is routed through the
Upright (4).
4.
Tip: Avoid pinching the wires.
Slide the
Upright (4) onto the Frame (1). Attach the
Upright with four M10 x 15mm Screws (65) and
four M10 Washers (31);
start all four Screws,
and then tighten them.
Do not press the Shield Cover (7) into place
yet.
3
4
4
4
1
7
7
58
1
65
65
31
31
Wire Tie
Avoid pinching
the wires
