7
3. Attach a Wheel (84) with the 3/8" x 2" Bolt (4)
and the 3/8" Nut (8) that you removed in step 1.
Do not overtighten the Nut; the Wheel must
turn freely.
83
4
8
3
84
2. With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (56) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (B)
and the shipping bracket (C).
Cut the shipping tie securing the Upright Wire
(38) to the Base (83). Locate a tie in the indi-
cated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach a Base Foot (81) to the Base (83) in the
location shown with a #8 x 1" Tek Screw (2) and
a Base Foot Spacer (13). Then, attach another
Base Foot (81) with only a #8 x 1" Tek Screw (2).
83
2
56
81
2
81
2
38
Hole
B
C
13
1.
Make sure that the power cord is unplugged.
Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),
and the shipping bracket (A) from the Base (83).
Repeat this step on the other side of the
treadmill.
Discard the shipping brackets. The
Bolts and Nuts will be used in steps 3 and 6.
83
4
A
8
1
