8
3. With the help of a second person, carefully tip
the incline trainer downward so that the Base
(80) is flat on the floor.
3
80
2. Identify the Right Upright (79), which is marked
“Right.” Hold the Right Upright near the incline
trainer.
See the lower inset drawing.
Tie the wire tie in
the Right Upright (79) around the end of the
Upright Wire (78).
See the upper inset draw-
ing.
Then, pull the other end of the wire tie until
the Upright Wire is routed out of the side hole
near the top of the Right Upright.
Orient the Right Upright (79) as shown. Attach
the Right Upright to the Base (80) with two 3/8"
x 3 1/2" Screws (5) and two 3/8" Star Washers
(8).
Start both Screws, and then tighten
them. Be careful not to pinch the Upright
Wire (78).
With the help of a second person, tip the incline
trainer onto its right side.
Have the second per-
son hold the incline trainer to prevent it from
falling.
Attach the Left Upright (not shown) as de-
scribed above.
Note: There are no wires on the
left side.
2
78
79
80
79
78
Wire
Tie
Wire
Tie
79
78
Wire
Tie
5
8
