8
6b
6a
6.
See drawing 6a.
Locate the Pedal Arm Roller
(32) on the Right Pedal Arm (12).
Lift the Right Ramp Cover (27) and set the
Pedal Arm Roller (32) on the Right Ramp (131).
Then, press the Right Ramp Cover into place.
Repeat this step on the other side of the
elliptical.
See drawing 6b.
Apply grease to the axle on
the right Crank Arm (39).
Orient a Pedal Arm Sleeve (46) so that the flat
side is facing the elliptical. Slide the Pedal Arm
Sleeve onto the axle on the right Crank Arm
(39).
Attach the Pedal Arm Sleeve (46) with an M8 x
25mm Patch Screw (121), a Large Axle Cover
(113), and an M8 Washer (95).
Tip: Avoid
damaging the Large Axle Cover when tight-
ening the Patch Screw.
Next, pull upward on the Latch (50) on the Right
Pedal Arm (12). Press the Right Pedal Arm onto
the Pedal Arm Sleeve (46).
Make sure that the
Right Pedal Arm latches into place.
Repeat this step on the other side of the
elliptical.
5. Identify the Right Pedal (14) and the Right
Pedal Arm (12), which are marked with “Right”
stickers, and orient them as shown.
Attach the Right Pedal (14) to the Right Pedal
Arm (12) with two M6 x 12mm Patch Screws
(111) and two M6 Washers (112);
do not
tighten the Patch Screws yet.
Next, tighten two M6 x 50mm Patch Screws
(62) and two M6 Washers (112) into the Right
Pedal Arm (12) and the Right Pedal (14).
Then,
tighten the two M6 x 12mm Patch Screws
(111).
Attach the Left Pedal (not shown) to the Left
Pedal Arm (not shown) in the same way.
5
14
12
111
112
32
12
95
113
46
Flat
Side
12
112
131
62
27
39
Grease
50
121
