7
4
1
2
117
4. Orient the Rear Stabilizer Cover (2) as shown.
Press the Mounts (117) on the Rear Stabilizer
Cover (2) into the Frame (1). Then, press the
Rear Stabilizer Cover into place.
5. Have a second person hold the Upright (4) near
the Frame (1).
See the inset drawing.
Locate the wire tie in
the lower end of the Upright (4). Tie the wire tie
to the Main Wire (110). Then, pull the upper end
of the wire tie until the Main Wire is routed
through the Upright.
Tip: To prevent the Main Wire (110) from
falling into the Upright (4), secure the Main
Wire with the wire tie
.
5
1
4
110
Wire
Tie
Wire
Tie
110
6.
Tip: Avoid pinching the Main Wire (110).
Set
the Upright (4) on the Frame (1).
Attach the Upright (4) with four M8 x 19mm
Patch Screws (82) and four M8 Star Washers
(122).
6
Avoid pinching the
Main Wire (110)
1
82
4
122
110
Summary of Contents for NTEL01310.3
Page 29: ...29 NOTES...
Page 30: ...30 NOTES...
