22
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the elliptical is used.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the
displayed heart rate appears to be too high or too low,
see step 5 on page 18.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
TABLET HOLDER TROUBLESHOOTING
If the tablet holder does
not stay in place, rotate
the tablet holder backward
and tighten the screw (A)
until the tablet holder stays
in place when it is rotated
to the desired position.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, first unplug the power
adapter.
Next, locate the Access Cover (29) in the Left Shield
(30). Remove the M4 x 16mm Screw (78) and the
Access Cover.
Next, loosen the Idler Screw (75). Then, tighten the
M10 x 55mm Screw (65) until the Drive Belt (59) is
tight.
When the Drive Belt (59) is tight, tighten the Idler
Screw (75). Then, reattach Access Cover (29) and plug
in the power adapter.
A
30
78
29
65
75
59
MAINTENANCE AND TROUBLESHOOTING
