11
11
28
2
39
62
64 61
12
11. Have a second person hold the Handlebar (39)
near the Upright (2). Locate the Pulse Wire
(28) extending from the Handlebar, and route
the Pulse Wire upward through the Upright as
shown.
Tip: Avoid pinching the Pulse Wire (28).
Attach the Handlebar (39) to the Upright (2) with
three M8 x 20mm Screws (62), three M8 Split
Washers (64), and three M8 Small Washers (61);
start all the Screws, and then tighten them.
55
7
12. Attach the Handlebar Cover (7) to the Upright (2)
with an M5 x 15mm Machine Screw (55).
Avoid pinching the
Pulse Wire (28)
2
13
4
53
28
42
13. While a second person holds the Console (4)
near the Upright (2), plug the Upper Wire (42)
and the Pulse Wire (28) into the receptacles on
the Console. The connectors on the Upper
Wire and the Pulse Wire should slide easily
into the receptacles and snap into place. If a
connector does not slide easily into a receptacle,
turn the connector and try again. If you do not
connect the connectors properly, the Console
may become damaged when you use the
elliptical.
Insert the excess wires into the Upright (2).
Tip: Avoid pinching the wires. Attach the
Console (4) to the Upright with four M4 x 16mm
Screws (53); start all the Screws, and then
tighten them.
Avoid pinching
the wires
2
