28
HOW TO USE THE REMOTE CONTROL
The convenient remote
control can be used to
control the speed and in-
cline of the treadmill and
the volume and channel
of the personal televi-
sion. The buttons on the
remote control function in
the same way as the cor-
responding buttons on
the console. When press-
ing buttons, point the re-
mote control toward the
sensor on the pulse bar.
Make sure that the sen-
sor is not exposed to di-
rect sunlight.
CAUTION: Keep the remote control
with you at all times while you are using the tread-
mill. Injury can result if another person changes
the speed or the incline of the treadmill while you
are using the treadmill.
HOW TO USE THE INFORMATION MODE
The console features an information mode that keeps
track of the total number of hours that the treadmill has
been used and the total number of miles that the walk-
ing belt has moved. The information mode also allows
you to select miles or kilometers as the unit of mea-
surement for the console, to turn on and turn off the
demo mode, to set channels into the television’s mem-
ory, and to reset all programs to the original settings.
Follow the steps below to use the information mode.
Hold down the Stop button while inserting the
key into the console.
A moment after the key is inserted, the lower right
corner of the screen will show the total number of
miles (or kilometers) that the walking belt has
moved and the total number of hours that the
treadmill has been used.
In addition, the word “English” (for miles) or
“Metric” (for kilometers) will appear on the screen.
Press the Speed increase button to change the
unit of measurement, if desired.
The words “Demo Off” or “Demo On” will also ap-
pear on the screen. The treadmill features a demo
mode that is intended to be used only when a
treadmill is displayed in a store. When the demo
mode is turned on, the power cord can be plugged
in, the key can be removed from the console, and
the indicators on the console will automatically
light in a preset sequence, although the buttons on
the console will not operate. Press the Speed de-
crease button to turn on or turn off the demo mode.
Press the Stop button again, select a cable
connection or an antenna connection, and
scan and memorize channels.
When the Stop button is pressed, the word
“Cable” or the word “Air” will appear on the
screen. If you have connected a CATV cable to
the treadmill, the “Cable” setting should be se-
lected; if you have connected an antenna, the
“Air” setting should be selected. Press the Power
button to change the setting, if necessary.
The word “Scan” will also appear on the screen.
To scan all of the channels available in your area,
press the Channel increase button. The television
will begin scanning the channels. When no broad-
cast signal is detected on a channel, the channel
will be skipped. When a signal is detected, the
channel will be stored in memory, a tone will
sound, and the next channel will be selected. This
process will be repeated until the highest channel
is reached. A series of tones will then sound.
Press the Stop button again and add or delete
channels.
After all valid channels available in your area have
been set into memory, you can manually add
channels or delete unwanted channels.
To add a channel,
first press the Channel buttons
until the desired channel number and the word
“ADD” appear on the screen. Press the Power
button to add the channel.
To delete an un-
wanted channel,
first press the Channel buttons
until the unwanted channel number and the word
“Remove” appear. Press the Power button to
delete the channel. Continue this process until
you have added all desired channels and deleted
all unwanted channels.
3
2
1
VOL
CHAN
INCL
SPEED
Sensor
