7.
Make sure that all parts are properly tightened before you use the treadmill.
Keep the included hex keys
for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill.
6. After the treadmill is moved to the location where it will
be used (see HOW TO MOVE THE TREADMILL on
page 8), make sure that both Rear Feet (5) and both
Wheels (not shown) rest firmly on your floor. If the
treadmill rocks slightly on your floor, loosen the Rear
Foot Locknut (111) above the right Rear Foot. Turn the
right Rear Foot clockwise or counterclockwise until the
rocking motion is eliminated. Then, retighten the Rear
Foot Locknut.
5
111
6
5. Plug the indicated end of the Power Cord (48) fully into
the treadmill as shown.
48
5
4.
Be careful to avoid pinching your hands or the Wire
Harness (not shown) during this step.
While a second person holds the Uprights (95, 97), re-
move the two Upright Bolts (96) used in step 1. Next,
slide the Uprights fully onto the brackets on the Frame
(not shown). Attach each Upright with four Upright Bolts
(96) as shown.
Firmly tighten all eight Upright Bolts.
Firmly tighten the eight Handrail Bolts (99).
7
5
111
99
99
99
95
96
96
97
4
