25
HOW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
must connect an antenna, a 75 ohm CATV cable, or
a VCR to the 75 ohm antenna terminal on the tread-
mill. See page 9 for instructions.
Follow the steps below to operate the television.
Insert the key into the console.
See GETTING STARTED on page 13.
Select the desired channel.
Press the C and – buttons to select a
channel. The number of the selected channel will
appear in the main display.
Adjust the volume.
Press the and – buttons to select the
desired volume. The selected volume setting will
appear in the main display.
Note: To listen to televi-
sion programs using
headphones (not in-
cluded), plug the head-
phones into the indicated
jack on the left side of
the console.
Change television settings if desired.
To change television settings, hold down the
C and – buttons for a few seconds until
the words TV SETUP appear in the main display,
Press the RESET button and enable or disable
the TV.
If the words TV POWER ON appear in the main
display when the RESET button is pressed, the
television will turn on each time the key is inserted.
To prevent the TV from being used, press the + or
– button above the ENTER AGE/WT button so the
words TV POWER OFF appear in the main dis-
play.
If you have enabled the TV, go to step 6. If
you have disabled the TV, go to step 9.
Press the RESET button again and select a
cable connection or an antenna connection.
If you are using a cable connection, press the + or
– button above the ENTER AGE/WT button until
the words TV MODE CABLE appear in the main
display. If you are using an antenna connection,
press the + or – button until the words TV MODE
ANTENNA appear.
Press the RESET button again and program TV
channels.
When the RESET button is pressed, the words
CHANNEL SCAN will appear in the main display.
The console has the capability to find and store in
memory all of the valid TV channels in your area.
Press the + or – button above the ENTER AGE/WT
button to start the channel scanning process.
The console will begin scanning all TV channels. If
no broadcast signal is detected on a channel, the
channel will be skipped; if a signal is detected, a
tone will sound and the channel will be stored in
memory. This process will continue until the high-
est channel is reached. The lowest channel stored
in memory will then appear in the main display.
7
6
5
4
3
2
1
Jack
