8
4. Hold a Bolt Spacer (14) inside the lower end of
the Right Upright (85). Insert a 3/8" x 4" Patch
Bolt (7) with a 3/8" Star Washer (11) into the
Right Upright and the Bolt Spacer.
Repeat this
step with a second Bolt Spacer (14), 3/8" x 4"
Patch Bolt (7), and 3/8" Star Washer (11).
Hold the Right Upright (85) against the Right
Upright Spacer (91).
Be careful not to pinch
the Upright Wire (87).
Tighten the 3/8" x 4"
Patch Bolts (7) until the heads of the Bolts touch
the Upright;
do not fully tighten the Bolts yet.
91
85
87
11
14
7
4
3. Identify the Right Upright (85) and the Right
Upright Spacer (91), which are marked with
“Right” stickers.
Insert the Upright Wire (87) through the Right
Upright Spacer (91) as shown. Set the Right
Upright Spacer on the Base (95).
See inset
drawings B and C. Make sure that the Right
Upright Spacer (91) sets flush against the
Base (95). If necessary, rotate the Spacer 180º.
Have a second person hold the Right Upright
(85) near the Base (95).
See inset drawing A.
Tie the wire tie in the Right Upright securely
around the end of the Upright Wire (87). Then,
pull the other end of the wire tie until the Upright
Wire is routed completely through the Right
Upright.
95
Wire Tie
87
85
91
87
91
Correct
Incorrect
95
95
3
Wire
Tie
85
87
A
B
C
91
