5
4. Raise the Upper Body Arm (27) to position as shown.
Make sure that the Snap Buttons (40) are fully
extended and locked into position on both sides of
the Hip Pad Slide (42).
5. The Console (66) requires two “AA” batteries. Alkaline
batteries are recommended. See the inset drawing.
Locate the Battery Door (89) on the back of the Console.
Press the indicated tab on the Battery Door and remove
the Battery Door. Press two batteries into the battery
compartment, with the negative ends of the batteries
touching the springs. Then, reattach the Battery Door.
Attach the Console (66) to the Upper Body Arm (27) by
firmly pressing it into place in the desired location.
6. Plug the Console Wire (47) and the Pulse Monitor (49)
into the indicated jacks on the Console (66).
See the inset drawing. Plug the other end of the
Console Wire (47) into the jack on the Upright (16).
7. Make sure that all parts are tightened before you use the
ski exerciser. To protect the floor from damage, place a
mat beneath the ski exerciser.
4
27
40
42
66
66
89
Tab
Batteries
27
47
49
Speed
Pulse
66
47
16
6
5
