12
12. Remove the packaging material from the bottom
of the Frame (56).
See the inset drawing.
Make sure that the 1/2"
Rear Leveling Foot Nuts (111) are threaded all
the way onto the Rear Leveling Feet (60). Turn
the two Rear Leveling Feet all the way into the
Frame.
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 27).
If one of the Rear Leveling Feet (60) doesnʼt sit
flat on the floor, turn the Rear Leveling Foot until
it does, and then tighten the 1/2" Rear Leveling
Foot Nut (111) against the Frame (56).
12
56
56
60
60
60
111
13.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 29 and 30).
11. Attach the upper end of the Storage Latch (53)
to the Frame (56) with a 3/8" x 1 3/4" Bolt (6)
and a 3/8" Nut (11). Note: It may be necessary
to move the Frame (56) back and forth to align
the Storage Latch with the Frame.
11
53
11
56
6
Summary of Contents for Powertread 1750
Page 33: ...33 NOTES...
