When you push the pad to change
operation modes, the unit will make
a beep sound to indicate that it is
changing modes.
model . Some models can be controlled by remote control. Some models have no remote
control function. See the following Fig.1 of the control panel Please refer to the REMOTE
CONTROL INSTRUCTIONS
Fig.1
Fan Pad
or Normal fan speed. Set the fan to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set
the fan to Normal.
The check filter feature is a reminder to clean the
will illuminate after 250 hours of
operation. To reset after cleaning the filter, press
Humidity Set Control Pads
TIMER Set Control Pads
Use the Up/Down pads to set the Auto
Start and Auto Stop time from 0.0 to 24.
The humidity level can be set within a range of
35% RH (relative humidity) to 85% RH
in 5% increments.
For drier air, press the
pad and set to a lower
percent value (%).
For damper air, press the
pad and set a higher
percent value (%).
Press to initiate the Auto Start and Auto stop feature,
Low fan
in dicator light
High fan
indicator light
Bucket full
indicator light
Continuous
operation on
indicator light
Timer on/off
indicator light
Continuous Operation Pad
Press to activate the continuous dehumidifying
mode.
Power Pad
Press to turn the dehumidifier on and off.
Display
8
CONTROL PADS ON THE DEHUMIDIFIER
Clean filter
indicator light
Control pads
Filter Pad
Timer Pad
NOTE:
The control panel of the unit you purchased may be slightly different according to its
for the remote
operation, if a remote control is included
Up/Down Pads
/
air filter for more efficient operation. The Clean
Filter indicator light
the filter pad and the light will go off.
Controls the fan speed. Press to select either High
with your appliance.
4
.
Auto defrost
operation
indicator light
at the same time as the
-
and
+
key pads
