5]
First steps:
(1) Remove the device from the packaging and place it on a stable underlay.
(2) Connect the device to a protective contact plug socket (a matching mains cable
is provided in the packaging).
(3) Slide the corresponding charging adapter and the required intermediate adapter
as needed (accessory) into the charging slots (figure 1). Do not use force, since
the adapter will snap into the insert with slight pressure. If used, ensure that the
arrow on the intermediate adapter faces upwards and that the connector located
on the adapter points to the left side of the charging slot. The system is not
compatible with other similar charging adapters (with 8-pin contact connectors)
from other manufacturers. (If you want to use these, please contact us.)
(4) Switch on: After you have inserted all necessary adapters, switch on the device
with the main switch (rear side). After switching on, all optical signal lamps glow
in sequence to check the functionality (LEDs) for approx. 0.5 seconds, and then
the red and blue signal maps (LEDs) go out, while the green signal lamps
indicate that the charging slots are ready for operation.
-
The charging station is now ready for operation!
–
Charging slot
O
Direct connector plug
O
Adapter
(Opening for battery)
O
Status LEDs
Functional principle: Insert adapter
