Nordmende WD515IX, User Manual

When building in the combination appliance, it is essential
to follow the instructions given in the operating and
installation instructions supplied with the combination
appliance.

All

dimensions

in

this

instruction

booklet

are

given

in

m

illimeters

.

Safety instruction for installation

~

Before connecting the appliance to the mains electricity supply make sure that the 

connection data on the data plate (voltage and frequency) correspond with the mains
electricity supply, otherwise the appliance could be damaged. Consult a qualified electrician 

if in any doubt.

~

The socket and on-off switch should be easily accessible after the appliance has been 

built in.

~

The warming drawer may only be built in combination with those appliances

quoted by the manufacturer as being suitable. The manufacturer cannot guarantee 
trouble-free operation if the appliance is operated in combination with appliances
other than those quoted by the manufacturer as being suitable.

~

When building in the warming drawer in combination with another suitable

appliance, the food warming drawer must be fitted above a fixed interim shelf in the 
housing unit. Please ensure that the housing unit can support both its weight and that
of the other appliance.

~

As the combination appliance is placed directly on top of the warming drawer

once it is built in, an interim shelf is not necessary between the two appliances.

~

The appliance must be built in so that the contents of the drawer can be seen. This is to 

avoid  scalding  from  hot  food  spilling  over.  There  must  be  enough space for the drawer to 

be pulled out fully.

~

The built-in dimensions for the warming drawer must be added to the built-in  dimensions 

of the combination microwave to establish the niche size  required.

2

1