Installation
A 1-25
E
2000 Nordson Corporation
All rights reserved
41-3000
V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
6. See Figure A 1-15. The trigger device, usually a photosensor, and
the enable/disable devices are connected at terminal block X6P on
the pattern control driver board. To connect these devices, refer to
Table A 1-4.
4130254
X6P
1
2
3
4
Fig. A 1-15 Terminal Block X6P on the Pattern Control Driver Board
1. Position 1
2. Position 2
3. Position 3
4. Position 4
Table A 1-4 Connections for Trigger and Enable/Disable Devices
Functional Description
Position on Terminal Block
X6P
Note
+15V
1
trigger
2
A
common
3
B
enable/disable
4
B
NOTE A: The driver board accepts either a current-sourcing or a
current-sinking trigger input.
B: If you are not using a remote enable/disable device, install a
jumper wire between positions 3 and 4.
