Installation
A 1-47
E
2000 Nordson Corporation
All rights reserved
41-3000
V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
Follow these guidelines when programming temperature settings:
S
Check the Manufacturer’s Safety Data Sheet (MSDS) for the
recommended operating temperature of the adhesive that you
will use.
S
For a zone to be on, the operating temperature must be set at
38
_
C (100
_
F) or higher.
S
Set the standby temperature 56
_
C (100
_
F) lower than the operating
temperature.
S
Before programming any temperature settings, make sure that the
overtemperature setpoint is at least 14
_
C (25
_
F) higher than the
highest operating setpoint used. Refer to Table A 1-12,
Feature No. 3.
Use this tip to program temperature settings quickly:
Zone
Procedure
All zones to the same
temperature
Follow the procedure
To Program All
Zones to the Same Temperature
.
Most zones to the same
temperature
1. First, follow the procedure
To
Program All Zones to the Same
Temperature
.
2. Then, follow the procedure
To
Program Setpoint and Standby
Temperatures Individually
to change
the settings that you wish.
