Pinch Valve Assembly
8
Part 768670A
.
2005 Nordson Corporation
Setting Up
The Pinch Valve Assembly is to be installed below a cyclone that supports
itself from the frame of the unit.
To allow safe and efficient operation ensure that the area to the front of the
assembly where the surge hopper hinges out is clear from obstruction.
When positioning the unit, ensure that the bottom plate of the cyclone is no
more than 40mm above the top of the surge hopper when the surge hopper
is in its down position. Therefore the lower edge of the cyclone may vary in
height from a minimum of 1150mm to a maximum of 1200mm.
Operation
See Fig 2.
1
2
Figure 2
Pinch Valve Assembly Operation.
