Pinch Valve Assembly
14
Part 768670A
.
2005 Nordson Corporation
Figure 7
Removing the sleeve.
6. Clean the valve body with compressed air.
7. Insert the new sleeve inside the body. Ensure that the side without a roll
pin is facing the new sleeve. Ensure that the large tab on the sleeve is
lined up with the large slot of the pinch valve body.
8. Rotate the sleeve 45 degrees to lock it in position.
9. Using long nosed pliers re--insert the roll pin.
10. Check conditions of seals and replace if damaged.
11. Re--assemble regulators and gauges to the pinch valve, and
re--assemble to the surge hopper.