© 2022 Nordson Corporation
5-4
Powder Path Removal
NOTE:
Skip these steps if not replacing the powder path. Go to page 5-5 to
reassemble the spray gun.
1. Perform the
Spray Gun Disassembly
procedure on page 5-2.
2. See Figure 5-4. Remove the elbow (13) from the inlet tube assembly (4).
3. Push the inlet tube assembly (16) up and out of the gun base (18).
4. Push the outlet tube assembly (4) out of the front of the gun body (6B).
5.
Blow off the inlet tube, outlet tube, and elbow, and replace them if the interiors are
worn or coated with impact-fused powder. If re-using the tubes, make sure the
O-rings are undamaged.
Powder Path Installation
1. See Figure 5-4. Install the outlet tube assembly (4) into the gun body (6B), with the
end of the tube flush with the end of the gun body.
2. Install the inlet tube assembly (16) into the lower body (15), then install the end of the
tube into the gun base (18).
3. Install the elbow (13) onto the inlet tube assembly, with the end oriented toward the
front of the spray gun as shown.
16
6B
18
13
4
Figure 5-4 Powder Path Replacement
Summary of Contents for Encore Select HD
