© 2022 Nordson Corporation
5-5
Spray Gun Re-Assembly
1. See Figure 5-5. Align the gun body with the lower body and slide them together,
engaging the internal ribs of the gun body with the lower body tabs.
2. Install the black nylon screw to secure the lower body to the gun body.
NOTE:
Make sure that the power supply harness is not pinched between the bulkhead
and the power supply.
Elbow Tube
Internal Ribs
Outlet Tube
Nylon Screw
Lower Body Tabs
Power Supply Harness
Bulkhead
Figure 5-5 Spray Gun Re-assembly
3.
Insert your finger into the outlet tube at the front of the spray gun and align the inside
end of the tube with the elbow, then push on the tube to seat it in the elbow.
NOTE:
To verify proper installation, place a flashlight inside the bottom of the inlet
adapter and verify the internal connections by looking through the outlet tube from the
front of the powder spray gun.
4. Connect the power supply harness to the gun cable, then tuck both through the
bottom hole in the bulkhead, into the gun body.
5. See Figure 5-1. Install the end cap (11), securing it to both the lower body and gun
body with the M3 screws.
6. Install the electrode assembly (3) into the the end of the outlet tube at the front of the
gun body. Make sure the electrode wire is not bent or broken.
NOTE:
The flat spray and conical nozzles each have their own respective electrode
holders.
7. Install the nozzle (2) on the electrode assembly, making sure the keys in the electrode
assembly slide into the slots on the nozzle.
8. Install the nozzle nut (1) over the nozzle and rotate clockwise to secure.
Summary of Contents for Encore Select HD
