Tribomatic Magnum Automatic Powder Spray Gun
6
E
2000 Nordson Corporation
All rights reserved
343 547A
Issued 8/00
Manual 37-37
The tubes are grounded through the gun body, ground wire, and the
control unit. The charge picked up by the tubes is displayed in
microampheres at the control unit. The display indicates how well the
powder is charging (the higher the number, the stronger the charge the
powder is receiving). The strength of the charge the powder receives will
vary depending on many factors, including the powder type and its speed
through the gun.
Refer to Table 1.
Table 1 Specifications
Powder Flow
Maximum
300 g/min (11 oz/min)*
Minimum
30 g/min (1 oz/min)*
Recommended 150 g/min (5 oz/min)
*These rates depend on the powder, pump
venturi, powder hose, and the length and
dimension of the hoses.
Pneumatic
Consumption
Maximum
700 l/min ( 24.7 cfm)
Normal
300 l/min (10.5 cfm)
Dimensions
Length
95 cm (37 in.)
Diameter
7.5 cm (3 in.)
Weight
2930 g (6.5 lbs)
Air Supply Quality
Air must be clean and dry.
Use a regenerative desiccant or a refrigerated
air dryer capable of producing a 3.4
_
C
(38
_
F) or lower dewpoint at 6.9 bar (100 psi).
Use a filter system with prefilters and
coalescent filters capable of removing oil,
water, and dirt in the submicron range.
2. Description
(contd)
Specifications
