Tribomatic Magnum Automatic Powder Spray Gun
14
E
2000 Nordson Corporation
All rights reserved
343 547A
Issued 8/00
Manual 37-37
WARNING:
Allow only qualified personnel to perform the
following tasks. Follow the safety instructions in this document
and all other related documentation.
Dust and powder accumulating on electrostatic equipment can cause
malfunctions resulting in fire and shock hazards. The entire system
should be cleaned periodically, along with the surrounding area.
1. Make sure all conductive equipment in the spray area, including the
guns, are connected to a true earth ground. The resistance from part
to ground, through the hangers and conveyor, must not exceed one
megohm. For best results, the resistance should be less than 500
Ω
.
2. Check the air supply filters and separators and the air dryer to make
sure they are operating properly.
WARNING:
Never blow out the chargetube with the ground
wire disconnected. A potentially dangerous charge will build up
in the chargetube which can cause severe electrical shock.
CAUTION:
Always blow out the feed hose in the direction of
powder flow (from pump to gun). Never blow out the feed hose
from the gun back into the pump.
3. Disconnect the air fittings from the diffuser.
4. Disconnect the powder feed hose from the pump.
5. Blow out the powder feed hose, diffuser, and pump.
6. Disassemble and clean the pump and diffuser. Replace worn parts.
7. Reassemble the pump and diffuser.
8. Reattach the powder feed hose and air fittings.
5. Maintenance
Daily
