45
2. Remove the decorative frame from the remote
controller. (The remote controller is inserted
in the decorative frame.)
3. Connect the remote controller wires to the
cord supplied with the water heater.
* If the Y-shaped terminal is not covered, the
exposed section may come into contact with
the mounting bracket resulting in improper
operation or failure.
4. Secure the remote controller wires by winding
them around the notches as shown in Fig. 1.
5. Attach the remote controller to the mounting
bracket. Insert the bottom of the remote
controller into the groove at the bottom of the
bracket and push in the 2 hooks on top of the
remote controller completely.
* If it is difficult to attach, do not try to force it
as it may result in broken hooks. Check for
proper alignment in the groove or for loose
wires obstructing the remote controller.
* Do not install on the
bracket by force, the
hooks may break.
Hooks
Groove
Mounting
bracket
Main remote
controller body
6. Secure the remote using the machine screws.
7. Attach the decorative frame which was
removed in the second step.
Push the 4 corners of the decorative frame
until there is a click.
* Incomplete
installation may
result in failures
such as switch
operation failure.
Note: To remove the decorative frame after
installation of the remote controller and
the frame, pull the entire decorative
frame forward while pressing the sections
indicated (where the fingers are) in the
figure below.
* If it does not come off, insert a flat head
driver into the notch at the bottom of the
decorative frame and slightly twist it to
remove (due caution is required not to
scratch the remote controller, decorative
frame or the wall in doing so).
Click
Click
Click
Click
Put fingers into this gap.
Main remote
controller body
Machine screw
(accessory part)
Rear side of the remote controller
Fig. 1
Winding around the notches
Pass the remote
controller wires
through the notch.
Section A
Insulating cover
(Do not remove
the cover.)
Mounting bracket
Remote controller wires
For wiring inside the wall
For exposed wiring
Remote controller wires
* Check the terminal is
covered with Section A
( ) of the insulating
cover (clear, see Fig. 1).
THIS SIDE UP
Remote controller cord
For exposed wiring, use scissors
or shears to carefully cut “the
wires inlet tab” of the decorative
frame to create slot for wires
before attaching to wall mount.
Wires inlet tab Decorative frame
Remove the remote
controller while pulling
the decorative frame
forward.
Decorative frame
Main remote
controller body
* Do not remove the remote controller wires
from the terminal block, connect these wires to
the remote controller cord.
* Do not remove the insulating cover (clear).
* Some modifications are required on the frame
to complete the installation. See note below.
