CP6, CP7, or CP8: Series Programmable Controller
Version 1.0
Page 7
MENU 3
Displays the current set points of the system. The date and time will only be displayed if a RTC
(real time clock) card is installed in the controller. The humidity and lighting set points will only
be displayed if each one is enabled.
K
EY
:
SET
Note:
If the password protection is used the following screen will be displayed before allowing access to the
SET POINTS screens. On initial start up there is no password protection, the passwords are set in the
PARAMETERS group. If no password protection is used the “ENTER PASSWORD” screen will not
be displayed.
Press the ENTER key to move the cursor to the four-digit password. Use the Up or Down Arrow key to
increase or decrease the number. When the correct password is displayed press the ENTER key to enter the
password. If the correct password was entered the corresponding screen will be displayed. If a wrong
password was entered “WRONG PASSWORD” will be displayed on the bottom line. The password can be
re-entered or press the MENU key to return to the System Status screen.
SET POINTS: Screen 1
Note: The schedule information will only be visable if a RTC is installed. If the schedule is enabled the
temperature will be set through the ramp and soak schedule. To disable the ramp and soak schedule
press the ENTER key to move the cursor to the schedule field. Use the Up or Down Arrow key to
disable the schedule. Press the ENTER key and the cursor will move to the upper left hand corner and
the set point will be visible. A full explanation of the ramp and soak schedule follows.
ENTER PASSWORD
0000
WRONG PASSWORD
SUN 00/00/00 00:00
Current Set
points
Temp:000.0
C
Hum:000.0% Lts:000%
Room Set Points 1
Temperature> 04.0
C
SCHEDULE >DISABLED
Goto Schedule >
