6
Operator's Manual
Cruzer M1
Flip-Style Sled Shelter
Visit us at:
www.rapala.ca
www.facebook.com/rapalaarmy
FRAME SUPPORT POLE ASSEMBLY
11. Start the assembly by locating (2) upper corner frame poles
(11239) and frame cross pole (11238). Insert swedged ends
of both upper corner frame poles into the frame cross
pole. Line up the screw holes provided in both parts and
fasten them together using (2) M4 x 18mm screws. Repeat this
step and use of hardware to assemble the other two upper
frame support poles.
SEE FIGURE 6
Note: A cordless screw driver and Phillips head bit may be
helpful for this step.
12. Assemble the lower frame pole by locating the (2) lower corner
poles (11240) and frame cross pole (11238). Insert swedged
ends of the lower corner poles into the frame cross support
pole. Line up the screw holes provided and fasten them to-
gether using (2) M4 x 18mm screws.
Note: Make sure you have assembled the upper and
lower frame poles with the correct swedged corner poles.
Reference the identification stickers on the corner poles
when assembling.
FRAME SUPPORT POLE TO SLED ASSEMBLY
13. Insert the (3) hinge poles from each hinge into the (3) upper
frame support poles. Push the snap button inward to allow
upper frame support pole to slide over hinge poles and adjust
to their lowest height (transport position).
SEE FIGURE 7
14. Unfold the skin and locate the Rapala® logo near the zippered
door, which is in the front of the sled. With the outer part of
the shelter skin laying face down locate the (3) fabric sleeves
on the ground in the bottom front, right side and left side of
the shelter. Slide the lower frame support pole through the
(3) fabric sleeves.
SEE FIGURE 8
15. Insert a hinge J-Pole from each hinge into the lower cross
frame pole. Push the snap button inward to allow lower cross
frame pole to slide over hinge J-poles. Snap lower cross frame
pole into place for the in-use position.
SEE FIGURE 8
snap button
fabr
ic sleev
e
sled
hinge assembly
snap button
corner frame pole
frame cross pole
M4 x 18mm screw
FIGURE 6
FIGURE 7
FIGURE 8
lower cross
frame pole
hinge J-pole
hinge poles
upper frame
support poles
