INSTALACIÓN DE LA MÁQUINA DE HIELO
1. Verifique que el equipo esté en buenas condiciones y que todas las piezas y accesorios estén presentes. Verifique el modelo y el número de serie en la etiqueta y tome nota
de ellos para referencia.
2. Limpie todas las superficies del equipo, incluyendo el área donde se hace el hielo y el depósito de hielo, con una esponja empapada en agua tibia potable y bicarbonato.
Lave y seque completamente el equipo.
3. Coloque el equipo en el sitio donde será utilizado. Asegúrese de que la superficie esté nivelada y pueda soportar el peso, que haya un drenaje de agua y suficiente espacio
para ventilación alrededor del equipo.
4. Use los niveladores ajustables de las patas si es necesario nivelar la máquina de hielo.
5. Conecte el filtro de entrada de agua y la manguera de agua de la máquina usando esquema de conexiones para instalación; si el lugar de la instalación ya tiene un equipo de
filtrado de agua, puede no ser necesario el filtro.
NOTA:
Asegúrese de instalar el filtro de modo que el agua fluya en el sentido indicado en la tapa del cabezal del filtro o en el cuerpo del filtro.
NOTA:
Esta máquina viene con un filtro de entrada de agua. Este filtro eliminará impurezas del agua usada mientras la máquina está funcionando.
En general, debe ser reemplazado cada 1 a 3 meses.
6.
Conecte la máquina al suministro de agua utilizando la manguera de entrada de agua de 3/4" que acompaña la máquina. Se recomienda instalar una válvula de agua
(no provista con esta máquina) en la línea de suministro de agua.
7.
Conecte la tubería de drenaje a la conexión de drenaje. Se recomienda que la tubería de drenaje tenga una diferencia de nivel superior a 1 pulg. por 3 pulg.
(3 cm por metro); y confirme que la tubería de drenaje no esté tapada. Se recomienda que la tubería de drenaje esté conectada a un orificio de drenaje abierto.
8.
Ninguna parte de la tubería de drenaje puede estar más alta que el orificio de drenaje en el equipo y tampoco puede tener inclinaciones.
9.
Confirme que se cumplan todos los requisitos de electricidad indicados en la etiqueta de especificaciones y que el equipo esté conectado a un interruptor de circuito
debidamente instalado, operativo y conectado a tierra.
10. Asegúrese de que el interruptor eléctrico esté en posición de apagado antes de conectar la máquina de hielo al suministro eléctrico.
25