ATOM Ku GaN 20-40-80W BUC &
SSPA
052910
27
052910_rA - Operator Manual for ATOM Ku
GaN Series 20-40-80W
U
SING
ATOMC
ONTROL
™
W
EB
I
NTERFACE
The Web Interface use and operation is similar to the ATOMControl interface. Web interface contains a
subset of ATOMControl functionalities. Refer to the ATOMControl Software Manual for instructions on
how to use the web interface (Norsat document number INS001219).
A
CCESSING
ATOM
SNMP
A
GENT
The integrated SNMP(v1) agent is accessible through standard default SNMP-service and trap ports of
161 and 162, respectively, using any NMS/SNMP servers and MIB browsers.
C
ONFIGURING
ATOM
SNMP
A
GENT
The SNMP(v1) agent settings for an ATOM-series device can be reviewed or
changed using the device’s
Command Line Interface. Ensure that a serial connection has been made to the device (refer to Figure 2 -
12 Setup Serial Port for details), and then use a terminal program or Norsat’s ATOMControl software to
send the appropriate command(s) to the device.
The default SNMP settings are as follows:
SNMP-service port:
161
SNMP-trap port:
162
SNMP read/write community:
public
SNMP manager IP address:
192.168.77.255
(255 on the 4
th
part of the address means to broadcast on the
192.168.77 subnet and allow any host in the subnet to access the SNMP
agent)
SNMP traps on fault:
enabled
To obtain status for, and enable/disable SNMP-service and trap:
Enabling SNMP-service allows the SNMP server to access ATOM device
’s data using Walk, Get
and Set. Enabling SNMP-trap also allows the SNMP server to receive traps generated by the
ATOM
device’s SNMP agent due to a fault or alarm detected on the device.
getsnmp<CR>
(obtain SNMP-service status)
getsnmptrap<CR>
(obtain SNMP-trap status)
setsnmp enable 0|1<CR>
(“0|1” means 0 or 1)
setsnmptrap enable 0|1<CR>
where 1 turns the function on, and 0 turns the function off
When SNMP enable is set to 0, also inhibits SNMP-trap functionalities. Setting SNMP-trap
enable to 0 does not inhibit SNMP-service functionalities.
To obtain and change SNMP-service and trap ports:
getport<CR>
(obtain a list of IP port designations)
setport snmp <port#><CR>
where port# for the SNMP-service port is a value between 161 and 169
